With the advancement of technology, we are able to have access to easy information and solutions at the touch of a button. However, not all technologies are as easy to use. For example, installing a water heater.
It is safe to say that there has been an improvement in the installation times for water heaters with each new generation of these devices released. This can be attributed to the increase in technology and ingenuity that has been put in place by manufacturers and installers alike.
A water heater typically takes between two hours and six hours, depending on its size, age, weather conditions, and whether or not it is being installed on an existing structure.
How Long Does It Take to Install a Water Heater?
The national average is around 45 minutes. However, there are factors that can make the installation process take longer than expected, including:
– Hvac systems in the way
– Floor plan
– Room size
– Age of the water heater
Some tips to consider include:
– Hiring an electrician or an installer with experience in your home’s plumbing system.
– Depending on your budget, it may be best to hire a company to install your water heater.
When to Install a New Water Heater in Your House
Installing a new water heater in your house can be very expensive. There are certain guidelines that you need to follow to know when it is the right time for you to install a new water heater in your house.
The following are the three factors that you should take into consideration before installing a new water heater:
– Your heating bills are high and they have not been reduced in the last five years
– Your home has a high level of radon
– Your home is over ten years old
In any of these cases, it is likely that installing a new water heater may not be an option. If your heating bills have not been reduced in the past few years, there is no reason to install one at this time since energy efficiency will eventually reduce them.
How to Install a Water Heater in the Right Location
Installing a water heater at the home can be a tricky process that needs certain steps to be followed.
First step is to determine the location of the water heater and make sure it’s not in the way of any utilities, such as power lines, cable TV, and telephone lines.
Next step is to make sure that there is enough room for proper ventilation.
Third step is to lay out pipes and electrical wiring so they don’t interfere with each other.
Fourth step is to turn off all electricity in the house before installing any work on this project. Fifth step is to install an electrical box for the new water heater. Finally, you can connect the gas pipes running outside of your home to a dedicated steel pipe. This will help ensure that you have an uninterrupted supply all the time.